Commission Delegated Directive 2014/5/EU of 18 October 2013 amending, for the purposes of adapting to technical progress, Annex IV to Directive 2011/65/EU of the European Parliament and of the Council as regards an exemption for lead in solders on printed circuit boards, termination coatings of electrical and electronic components and coatings of printed circuit boards, solders for connecting wires and cables, solders connecting transducers and sensors that are used durably at a temperature below – 20 °C under normal operating and storage conditions
Proposed act with possible EEA relevance
Act under scrutiny by EEA EFTA
Draft Joint Committee Decision (JCD) under consideration
Entry into force of Joint Committee Decision (JCD) pending
Incorporated into the EEA Agreement and in force
Incorporated into the EEA Agreement but no longer in force
Legal status
EU legal act incorporated into the EEA Agreement by a Joint Committee Decision (JCD) Area (EEA Agreement)
II Technical Regulations, Standards, Testing and Certification
II.XV Dangerous Substances
Joint committee decision (JCD)
122/2014 In force in the EEA
Yes Legal documents
Commission Delegated Directive 2014/5/EU of 18 October 2013 amending, for the purposes of adapting to technical progress, Annex IV to Directive 2011/65/EU of the European Parliament and of the Council as regards an exemption for lead in solders on printed circuit boards, termination coatings of electrical and electronic components and coatings of printed circuit boards, solders for connecting wires and cables, solders connecting transducers and sensors that are used durably at a temperature below – 20 °C under normal operating and storage conditions
Framseld tilskipun framkvæmdastjórnarinnar 2014/5/ESB frá 18. október 2013 um breytingu á IV. viðauka við tilskipun Evrópuþingsins og ráðsins 2011/65/ESB, að því er varðar undanþágu fyrir blý í lóðningarefni á prentplötur, húðir á úttakstengjum á rafmagns- og rafeindaíhlutum og húðir á prentplötum, lóðningarefni til að tengja víra og rafstrengi og lóðningarefni til að tengja ferjöld og skynjara, sem eru notuð varanlega við hitastig undir - 20° C við eðlileg notkunar- og geymsluskilyrði, í því skyni að laga viðaukann að tækniframförum
Delegierte Richtlinie 2014/5/EU der Kommission vom 18. Oktober 2013 zur Änderung — zwecks Anpassung an den technischen Fortschritt — des Anhangs IV der Richtlinie 2011/65/EU des Europäischen Parlaments und des Rates hinsichtlich einer Ausnahme für Blei in Loten auf Leiterplatten, in der Beschichtung von Anschlüssen von elektrischen und elektronischen Komponenten und in Beschichtungen von Leiterplatten, in Loten zur Verbindung von Drähten und Kabeln, in Loten zur Verbindung von Wandlern und Sensoren, die dauerhaft bei einer Temperatur von unter – 20 °C unter normalen Betriebs- und Lagerbedingungen verwendet werden
Delegert kommisjonsdirektiv 2014/5/EU av 18. oktober 2013 om endring, med sikte på tilpasning til den tekniske utvikling, av vedlegg IV til europaparlaments- og rådsdirektiv 2011/65/EU med hensyn til unntak for bruk av bly i loddemateriale på kretskort, belegg på termineringer på elektriske og elektroniske komponenter og belegg på kretskort, i loddemateriale for tilkopling av ledninger og kabler og i loddemateriale for tilkopling av transdusere og følere som brukes varig ved en temperatur under -20 °C ved normale bruks- og lagringsforhold
History
28.06.2014
Adopted JCD confirmed entry into force date
28.06.2014
Compliance date in the EEA
27.06.2014
Adoption of Joint Commitee Decision (JCD) incorporating the act into the EEA Agreement
15.04.2014
Draft Joint Commitee Decision (JCD) incorporating the act into the EEA Agreement sent to Commission
18.10.2013
Adoption date in the EU
29.01.2014
Compliance date in the EU
Disclaimer: EEA-Lex is provided for information purposes only. The information is not guaranteed or promised to be current or complete and is not intended to replace any applicable legal sources.